What should be paid attention to when using air motors and cylinders?
The air motor must be well lubricated during use. Generally, in the entire pneumatic system circuit, an oil mist device is installed in front of the air motor control valve, and the oil is supplemented on time, so that the oil mist enters the air motor after being mixed into the air, so as to achieve sufficient lubrication.
When using the cylinder, the ambient temperature should be -35 plus 80 degree ; the test should be carried out under 1.5 times the working pressure before installation, and there should be no air leakage; all working surfaces should be coated with grease when assembling; the air inlet of the installation A lubricator must be installed, and a dust cover must be installed in the dusty place; the piston rod should be installed as far as possible to bear the tensile load on the axis; if the load changes during the stroke, a cylinder with sufficient output power should be used, and attached Cushioning device; in most cases the full stroke is not used.
